All ideas

In RCDC we are using 2 types of Design Codes Combinations like this. IS 456 + IS 13920-1993 IS 456 + IS 13920-2016 Can't we have Third Design Code IS 456 + IS 13920-1993 + IS 13920-2016 in RCDC (SACD) or STAAD Pro like this? Because In IS 456 w...

I think it will be better during design in RCDC,to select the concrete grade of column separately from that of wall.Concrete grade should be divided into two parts one for columns and the other one for walls.

When completing a design in RCDC if the member fails, you cannot edit the rebar. I would like to be able to edit reinforcement. Then after the reinforcement is added, I would like it to print a full report so I can see what is failing. This is so ...

Please, add Brazilian codes: Some of the most important codes: ABNT-NBR 6118 (concrete design) ABNT-NBR 6122 (foundations design) ABNT-NBR 8800 (hot-rolled steel design) ABNT-NBR 14762 (cold-formed steel design) ABNT-NBR 7190 (wood design) ABNT-NB...

Hello i would like to suggest that RCDC to upgrade and enable it to design any type of beam shape which is created in USERTABLE of STAAD.Pro. i tried early to create a T beam in USERTABLE but after analysis this T beam was not recognized by RCDC

Dear bentley software please make one time to choose default materials (concrete reinforcement) for design footing, column ,beam, slab in RCDC, because it waste too time when you select materials and you back to staad change something then you cho...

when you make grouping column, beam, slab, & footing in RCDC, for make simplicity, the software not give same name, please add this feature if possible.

Iam designing a reinforced concrete ramp as a plate,the difficult iam facing is there is no BS 8110 in analytical design,and with the available BS 8007 i cant check deflection of the plate.

During design of beam in rcdc,if i put a check of crack width the software will not design and it gives a message written "Cannot find column [StAstTop] but if i dont check for crack width the software works perfectly.Need a help on this problem b...

May you please improve the design of foundation of parametric wall in RCDC,lets say if i want my footing size to be 1500mm by 300mm depth,but the left side i want it to be 400mm from centre of wall and right side to be 1100mm from centre of wall,c...