Skip to Main Content
ADD A NEW IDEA

All ideas

Showing 59 of 59

Testing ideas portal 2

This is a test without logging in
Guest over 3 years ago in  0 Needs review

RCDC DESIGN OF A BEAM OF ANY SHAPE CREATED IN USERTABLE

Hello i would like to suggest that RCDC to upgrade and enable it to design any type of beam shape which is created in USERTABLE of STAAD.Pro. i tried early to create a T beam in USERTABLE but after analysis this T beam was not recognized by RCDC
Joseph Lucas Magare almost 2 years ago in  1 Needs review

Third Design Code IS 456 + IS 13920-1993 + IS 13920-2016 in RCDC | STAAD

In RCDC we are using 2 types of Design Codes Combinations like this. IS 456 + IS 13920-1993 IS 456 + IS 13920-2016 Can't we have Third Design Code IS 456 + IS 13920-1993 + IS 13920-2016 in RCDC (SACD) or STAAD Pro like this? Because In IS 456 w...
Guest almost 4 years ago in  1 Needs review

CONCRETE GRADE SELECTION IN RCDC

I think it will be better during design in RCDC,to select the concrete grade of column separately from that of wall.Concrete grade should be divided into two parts one for columns and the other one for walls.
Joseph Lucas Magare almost 4 years ago in  0 Future consideration

Default material choosing (footing, column, beam, slab) one time in RCDC

Dear bentley software please make one time to choose default materials (concrete reinforcement) for design footing, column ,beam, slab in RCDC, because it waste too time when you select materials and you back to staad change something then you cho...
Guest almost 2 years ago in  1 Needs review

give same name when grouping beam or column in RCDC

when you make grouping column, beam, slab, & footing in RCDC, for make simplicity, the software not give same name, please add this feature if possible.
Guest almost 3 years ago in  1 Future consideration

DEFLECTION CHECK OF RCC PLATES (RAMP)

Iam designing a reinforced concrete ramp as a plate,the difficult iam facing is there is no BS 8110 in analytical design,and with the available BS 8007 i cant check deflection of the plate.
Joseph Lucas Magare almost 4 years ago in  1 Needs review

RCDC ERROR WHILE DESIGNING BEAM (STAAD PRO CONNECT EDITION UPDATE 5)

During design of beam in rcdc,if i put a check of crack width the software will not design and it gives a message written "Cannot find column [StAstTop] but if i dont check for crack width the software works perfectly.Need a help on this problem b...
Joseph Lucas Magare almost 4 years ago in  1 Needs review

PARAMETRIC WALL FOUNDATION DESIGN

May you please improve the design of foundation of parametric wall in RCDC,lets say if i want my footing size to be 1500mm by 300mm depth,but the left side i want it to be 400mm from centre of wall and right side to be 1100mm from centre of wall,c...
Joseph Lucas Magare almost 4 years ago in  1 Needs review